Section-30, Cable Bundle 1, Connecting to I/O enclosure (1G3/1G4)

Procedure

  1. At the rear of the rack, locate the two cables hanging down that are wrapped with a blue hook-and-loop cable tie.
    Note: The cable label location codes are shown in Figure 1.
  2. Route the two cables up the right sidewall of the rack and connect them to the I/O enclosure PCN card. See Figure 1. Use the blue cable tie to fasten them to the right side of the cable bundle 2 cable tie bar. See Figure 2.
    Figure 1. Location codes, I/O enclosure (2U) adapter (PCN)
    Location codes, I/O enclosure (2U) adapter (PCN)
    Figure 2. PCN cables and fastened to cable tie bar
    PCN cables and fastened to cable tie bar