Section-22, Cable bundle 1, installing the upper CEC enclosure (XC1) cable tie bar and connecting cables

Procedure

  1. Locate the cable tie bar with the white location code label for CEC (XC1-Upper).
  2. Remove the bubble-wrap from the CEC (XC1, upper) cable tie bar cable group.
  3. Install the nut clips for the upper CEC (XC1) cable tie.
    1. Install a nutclip in rack rail hole 5 (white arrow), left and right sides. See Figure 1.
      Figure 1. CEC enclosure cable tie bar screw position
      CEC enclosure cable tie bar screw position
  4. Install the upper CEC (XC1) cable tie bar to the nut clips.
  5. Connect the cables to the CEC (XC1, upper). See Figure 2.
    Figure 2. CEC enclosure location codes (rear view) (Models 983)
    CEC enclosure location codes (rear view) (Models 983)
  6. Use the hook-and-loop fastener and tie the power cables to the power supplies.