Section-34, Cable bundle 3, installing cable tie bar at upper flash enclosure I1-F03

Procedure

  1. For reference only.
    1. Figure 1 shows only cable bundle 3 fully installed in the rack.
    2. Section-47, Table 3 lists the cable groups and cable types.
    Figure 1. Cable bundle 3 fully installed
    Cable bundle 3 fully installed
  2. Locate cable bundle 3 in Box 10 of 10.
  3. At the rear of the rack, install the flash enclosure pair cable tie bar.
    1. Locate the cable tie bar. The right-end white location label has Cable Bundle 3, I1-1F3.
    2. Install the cable tie bar behind the upper flash enclosure (I1-F3). Use a screw in the top hole (white arrow) of the rail. See Figure 2.
      Note: The yellow arrow is the I/O enclosure cable tie bar.
      Figure 2. Upper flash enclosure, cable tie bar, left
      Upper flash enclosure, cable tie bar, left