Section-31, Installing the lower flash enclosure (I1-F04) on the rails

Procedure

  1. Locate the flash enclosure in Box 8 of 10.
  2. Ensure the white inventory label at the top front of the enclosure has I1-F04.
  3. Install the enclosure on the rails, slide it fully in, and secure with screws in holes Callout label 2 and Callout label 5. See Figure 1.
    Figure 1. Flash enclosure rail screw holes, left front (rear similar)
    Flash enclosure rail screw holes, left front
  4. Remove the white foam protection from the rear of the enclosure.