MEMDIMM

The failing component is one of the memory DIMMs.

Before you begin

Note: Storage complex repair actions must always be managed from the management console. To replace any FRUs identified in this procedure, use Storage Facility Management > storage facility > Exchange Parts. If the FRUs are listed in this or another Serviceable Event, select them from there.

Procedure

  1. For Model 961, the possible failing memory DIMMs are P1-Cx-Cy
    x = 14-17 (CEC enclosure memory card)
    y = 1-4, 7-10 (CEC enclosure memory module)

    This ends the procedure for Model 961.

  2. For Model 941 and Model 951, replace the FRUs in the order shown until the problem is resolved.
    Table 1. Replacing the failing part
    Unit Failing part How to replace the failing part
    CEC enclosure - Processor 1 DIMM 1 P2-C1-C1
    DIMM 2 P2-C1-C2
    DIMM 3 P2-C1-C3
    DIMM 4 P2-C1-C4
    DIMM 5 P2-C1-C5
    DIMM 5 P2-C1-C5
    DIMM 6 P2-C1-C6
    DIMM 7 P2-C1-C7
    DIMM 8 P2-C1-C8
    DIMM 9 P2-C1-C9
    DIMM 10 P2-C1-C10
    DIMM 11 P2-C1-C11
    DIMM 12 P2-C1-C12    		 Refer to Exchanging parts.
    CEC enclosure - Processor 2 DIMM 1 P2-C2-C1
    DIMM 2 P2-C2-C2
    DIMM 3 P2-C2-C3
    DIMM 4 P2-C2-C4
    DIMM 5 P2-C2-C5
    DIMM 6 P2-C2-C6
    DIMM 7 P2-C2-C7
    DIMM 8 P2-C2-C8
    DIMM 9 P2-C1-C9
    DIMM 10 P2-C1-C10
    DIMM 11 P2-C1-C11
    DIMM 12 P2-C1-C12    		 Refer to Exchanging parts.

    This ends the procedure for Model 941 and Model 951.