Disconnecting Rack-2 I/O enclosure power

Use these procedures to disconnect the power input cables from each I/O enclosure for Rack-2.

Procedure

  1. You must do the following step to ensure that the installation does not fail.
  2. At the front of Rack-2, disconnect the power input cables from power supplies E1 and E2 (Figure 2) on each I/O enclosure 2B1 (if present), 2B2 (if present), 2B3 and 2B4 (Figure 1).
    Figure 1. I/O enclosure locations (front) (models 98x, 8xE)
    Image that shows the front I/O enclosure locations (models 98x).
    Note: Enclosures 1B1, 1B2, 2B1, and 2B2 are not present in some models.
    Figure 2. I/O enclosure locations (front) (models 98x, 8xE)
    I/O enclosure locations (front) (models 98x)
  3. Go to the next section.