Exchange the CEC enclosure media backplane assembly

Before you begin

Icon for electrostatic discharge wrist strapUse approved ESD procedures to prevent damage.

Attention:
  • This procedure is not a stand-alone procedure. Customer disruption and damage to the hardware might occur when microcode and power boundaries are not in the proper conditions for this service action.
  • If a serviceable event FRU repair directed you to this procedure, the microcode and power boundaries are already set.
  • If a serviceable event FRU repair did not direct you to this procedure, see MAP1230 Replace a FRU without using a serviceable event.
Notes:
  • All the cables and FRUs to be removed must be uniquely identified so they can be reinstalled correctly.
  • If an installed earthquake resistance kit prevents you from accessing this FRU, refer to MAP1600.

Remove the media backplane assembly

Procedure

  1. Verify that the CEC enclosure is in the "power off" state before you continue. (The CEC enclosure should already be in the power off state.)
    Note: If this FRU has a FRU identify indicator LED, it is no longer lit.

    If you have not already located the FRU to be replaced, use the location code listed in the serviceable event FRU list. See MAP1245 Finding FRUs by using location codes.

  2. At the rear of the storage facility, view both CEC enclosure power supplies.
    Figure 1. CEC enclosure DC good LEDs
    CEC enclosure DC good LEDs

    Are both DC GOOD LEDs flashing?

  3. Remove all power from the CEC enclosure.
    • At the rear of the CEC enclosure, disconnect the power input cables Callout label A to both CEC enclosure power supplies.
    • At the CEC enclosure control panel, observe the green Power® Present icon, beneath the white Power button.
      • If it is slow flashing, the CEC enclosure is still in the power-off state. DO NOT CONTINUE. Ensure that you have unplugged the power cables.
      • If it is off, go to the next step.
    Figure 2. CEC enclosure (rear)
    CEC enclosure (rear)
  4. At the front of the rack, while pushing the blue plastic retaining tab Callout label A to the right, pull the DVD-RAM drive Callout label B and filler panel out. See Figure 3.
    Figure 3. Removing the DVD-RAM drive and filler panel
    Remove the DVD-RAM drive
  5. Remove the media backplane assembly. See Figure 4.
    1. Pull the two orange locking knobs Callout label A out until they unlock.
    2. Grasp the media backplane assembly Callout label B and slowly pull it out of the disk drive backplane assembly.
    Figure 4. Removing the media backplane assembly
    Remove the media device enclosure.

Install the media backplane assembly

Procedure

  1. Pivot the CEC enclosure fan orange pull rings up out of the way.
  2. Align the media backplane assembly with the disk drive backplane assembly opening.
  3. Gently slide the media tray into place, and then push the two orange locking knobs into the locked position.
  4. While pushing the blue plastic retaining tab to the right, push the DVD-RAM drive and filler panel in fully.
  5. At the rear of the CEC enclosure, connect the power input cables to both CEC enclosure power supplies.
  6. Ensure that the CEC enclosure is in the power-off state before you continue. At the CEC enclosure control panel, wait for the green Power Present icon, beneath the white Power button to slow blink, and then continue the repair.
  7. Exit this service information center parts exchange procedure and return to the procedure that sent you here.